NOTE for VM-8500LA: Make sure that the "AV OUT/IN" is in the "OUT" position.

1. Disconnect the VHF antenna leads from the rear of the TV receiver.

NOTE: Leave the UHF antenna leads connected to the TV.

2.Connect the VHF antenna lead to "IN FROM ANT" on the RF converter unit. If the cable is round (75 ohm), it will connect directly to the "IN FROM ANT". If it is the flat type (300-ohm), connect it to the antenna adaptor (300-ohm to 75-ohm) and slip the adaptor on to the "IN FROM ANT" terminal.

3.Connect the 75-ohm coaxial cable with antenna adaptor to "OUT TO TV" on the RF converter unit.

4.Connect the other end to the VHF antenna terminal on the TV, as illustrated.

5.Connect the connector cable from RF converter unit to "RF DC OUT", "AUDIO" and "VIDEO" jacks on the camcorder.

6.Turn on the TV and set to channel 3 unless channel 3 is one of the TV stations in your area. If channel 3 is used in your area, set your TV to channel 4.

7.Set the RF channel selector on the RF converter unit to "CH3" or "CH4" to match the channel selector on your TV.

8.Perform same procedures in steps 4 through 7 of "Example 1".

NOTE: If you want to watch a TV program with camcorder connected as illustrated, slide "CAM/OFF/VIDEO" of the camcorder to "OFF".

CAMCORDER TO VCR DUBBING