Advanced Techniques

- 47 -

hold it. If the remote control code has been set, the VCR channel is counted up automatically.

Note: Your VCR should have an infrared remote control.

Note: If the channel on the VCR does not change with the above operation, you need to switch the remote control code of your VCR. Refer to the VCR's instruction manual. If the channel still does not change after you have changed the VCR's remote control code, the edit remote control cannot operate your VCR.

VCR Brands

Press VCR SET and This Button

Hitachi

REVERSE

 

Sony

PROGRAM

Panasonic

FORWARD

Toshiba

IN

 

Mitsubishi

COPY START

Sanyo

OUT

 

Sharp

 

 

NEC

 

 

JVC

 

 

Akai

A/V DUB

 

Gold Star

 

 

PHILIPS

 

 

RCA

DISPLAY

 

Zenith

COUNTER RESET

Magnavox

TITLE ON/OFF

Note: The remote control code is held in memory until it is changed or the batteries are replaced.

Note: Point the remote control straight at the VCR's infrared receiver for operation.

Note: Use the remote control indoors. When the infrared receivers of the VCR and camcorder are exposed to direct sunlight or strong artificial light, the remote control may not operate correctly.

Note: The remote control cannot be operated if there is an obstacle between the remote control and infrared receiver. Especially, be careful of this during dubbing.

Note: When the edit remote control is connected to the camcorder, the buttons marked * in the figure above perform the same operations as those of the other remote control provided.

Operation

You can select up to four different scenes or segments to be copied at one time.

Note: If sunlight or strong artificial light strikes the camcorder's infrared receiver, the editing operation may not be possible.

Programmable Edit Hookup

1.Connect the edit remote control to the camcorder, and then connect the AV stereo output cable as illustrated above.

2.Insert a recorded tape into the camcorder.