Hitachi VT-FX611A owner manual Option 3--SomeChannels Scrambled

Advanced Operartons (Cable Box Hookups_ -;_; _'

Check all the TV and VCR functions. If you don't get all the functions you want, proceed with Option 2.

Option 2--All Channels Unscrambled

1.Remove the cable company's line from the back of the cable box that goes to your TV. Connect it to the IN FROM ANT lower jack on the back of the VCR.

2.Using the 75 ohm coaxial cable supplied with the VCR, connect either end to the VCR's OUT TO TV upper jack.

3.Connect the other end of the 75 ohm cable to the TV, in the same place where you removed the cable line.

Note: You will end Up with an extra cable that 0riginai!Y went from the Cable box 1 to the TV;

Check all the TV and VCR functions. If you don't get all the functions you want, proceed with Option 3.

Option 3--Some Channels Scrambled

This hookup requires three coaxial jumpers with connectors, a 1-into-2 splitter, and an A-or-B switch box.

1.Disconnect the cable from the cable box and attach it to the input line of the 1- into-2 splitter.

2.Using a coaxial jumper, reconnect one of the splitter outputs to the cable box's input that you just freed up.

3.Using a second coaxial jumper, connect the other splitter output to the A of the a-or-B switch.

4.Using the cable box output line, connect the cable box receptacle to the B of the A-or-B switch.

5.Using a third coaxial jumper, connect the output of the A-or-B switch to the input of the VCR.

4!