PRACTICAL APPLICATIONS
WARNING
To avoid personal injury, never remove or place a workpiece on the table while the tool is being operated.
Never place your limbs inside of the line next to warning sign while the tool is being operated. This may cause hazardous conditions (see Fig. 5).
Warning Sign
Line | Warning Sign Line |
Fig. 5
CAUTION
It is dangerous to remove or install the workpiece while the saw blade is turning.
When sawing, clean off the shavings from the turntable.
If the shavings accumulate too much, the saw blade from the cutting material will be exposed. Never subject your hand or anything else to go near the
exposed blade.
1.Tightly secure the material by vise assembly to be cut so that it does not move during cutting
2.Switch operation
Pulling the trigger turns the switch on. Releasing the trigger turns the switch off.
3.Holder (B) adjustment (Fig. 6)
Loosen the 6 mm bolt with the supplied 10 mm box wrench. Adjust the holder (B) until its bottom surface contacts the bench or the floor surface.
Screw Holder | Knob |
|
6 mm Wing Bolt (B)
Vise Plate
Fence (B)
Vise Shaft
6 mm Wing Bolt (A) | Workpiece |
|
Fig. 7
(2)The screw holder can be raised or lowered according to the height of the workpiece by loosening the 6 mm wing bolt (B). After the adjustment, firmly tighten the 6 mm wing bolt (B) and fix the screw holder.
(3)Turn the upper knob and securely fix the workpiece
in position.
WARNING
Always firmly clamp or vise to secure the workpiece to the fence; otherwise the workpiece might be thrust from the table and cause bodily harm.
CAUTION
Always confirm that the motor head does not contact the vise assembly when it is lowered for cutting. If
there is any danger that it may do so, loosen the 6
mm wing bolt and move the vise assembly to a position where it will not contact the saw blade.
5.Confirmation for use of sub fence
This power tool is equiped with a sub fence (See Fig. 2). In the case of direct angle cutting and angle cutting, use the sub fence. Then you can realize stable cutting of the material with a wide back face.
In the case of left bavel cutting, raise the sub fence up as illustrated in Fig. 8 and then turn it counterclockwise.
Sub Fence
Turn
Holder (B)
Adjust the holder until its bottom surface contacts the work bench surface.
6 mm Bolt
Move
Fence (B)
Fig. 6
4.Using the Vise Assembly (Standard accessory) (Fig. 7)
(1) The vise assembly can be mounted on either the left fence {Fence (B)} or the right fence {Fence (A)} by loosening the 6 mm wing bolt (A).
Fig. 8
WARNING
In the case of left bevel cutting, turn the sub fence counterclockwise. Unless it is turned counterclockwise, the main bady or saw blade may contact the sub fence, resulting in an injury.
6.Using an ink line
Upon lowering the motor section, the lower guard is raised and the saw blade appears.
Align the ink line with the saw blade.
6