NOTE

￿Perform cutting by overlapping the ink line with the laser line.

￿When the ink line and the laser line are overlapped, the strength and weakness of light will change, resulting in a stable cutting operation because you can easily discern the conformity of lines. This ensures the minimum cutting errors.

￿In outdoor or near-the-window operations, it may become difficult to observe the laser line due to the sunlight. Under such circumstances, move to a place that is not directly under the sunlight and engage in the operation.

￿Do not tug on the cord behind the motor head or hook your finger, wood and the like around it; otherwise, the cord may come off and the laser marker may not be lit up.

￿Check and make sure on a periodic basis if the position of the laser line is in order. As regards the checking method, draw a right-angle ink line on the workpiece with the height of about 38 mm and the width of 89 mm, and check that the laser line is in line with the ink line [The deviation between the ink line and the laser line should be less than the ink line width (0.5 mm)] (Fig. 13).

Laser line

Marking (pre-marked)

 

 

 

Fig.

13

 

8. DIGITAL DISPLAY PANEL (for C12LCH and C12LC)

Miter angle

 

Bevel angle

window

 

window

(Displays arrows

 

(Displays arrows

show angle and

 

showing motor

direction that

 

 

 

head bevel angle

 

 

turntable is

 

 

 

 

and bevel

rotating. Left is

 

 

 

 

direction. Left is

←, Right is →.)

 

 

 

 

←, Right is →.)

 

 

 

 

 

Bevel angle

Miter angle

 

 

reset button

reset button

 

 

 

Back light ON/OFF switch (Press and the switch illuminates. Press again and the lighting turns off.)

Fig. 14

(1)Turning on the digital display switch shows 0° for both miter and bevel angle, regardless of main unit angle.

(2)Align the main unit angle with the tilt angle (0°) and miter angle (0°) and hold down their reset buttons for at least 0.2 seconds.

(3)Turning on the laser marker switch while the digital display switch is on, lights up the laser marker. (On the C12FCH, only the laser marker switch.)

Laser marker switch (for C12LCH/C12FCH)

Digital display switch (for C12LCH/C12LC) (Also serves as laser marker power switch.)

Fig. 15

CAUTION

￿When operating the digital panel, have the motor head section at the top limit position and the blade stopped.

￿If the figure shown on the miter angle digital display

is different from the positive stop angle (for example, 45.0° → 45.5°, 31.6° → 32.0°) then the positive stop has probably deviated slightly from its correct position. If this happens, do as follows.

(1)Move the turntable left and right with the side handle loosened, and set the turntable to the correct position.

(2)If the figures on the display and positive stop still do not match, then return the turntable to the 0° position. Next move the turntable left and right with the side handle loosened as shown in Fig. 15. After setting it to the correct position 0°, press the reset button again.

Reset Button

Side Handle

Move the turntable left and right with the side handle loosened and set it to the correct position.

Fig. 16

NOTE

￿Before starting to cut, align the main unit to the miter angle 0° and the bevel angle 0° and hold down the reset buttons for at least 0.2 seconds. If you press the digital display switch to ON without aligning the main unit to 0°, then the figures appearing on the digital display and the main unit angle will not match.

￿The laser marker will not light up if the digital display switch is turned off. (only on C12LCH)

8