7. Using depth gauge (Fig. 14)
(1)Loosen the knob on the side handle, and insert the depth gauge into the mounting hole on the side handle.
(2)Adjust the depth gauge position according to the depth of the hole and tighten the knob bolt securely.
8. How to use the drill bit (taper shank) and the taper shank adaptor
(1)Mount the taper shank adaptor to the rotary hammer. (Fig. 15)
(2)Mount the drill bit (taper shank) to the taper shank adaptor. (Fig. 15)
(3)Turn the switch ON, and drill a hole in prescribed depth.
(4)To remove the drill bit (taper shank), insert the cotter into the slot of the taper shank adaptor and strike the head of the cotter with a manual hammer supporting on the rests. (Fig. 16)
Drill Bit | Grip |
| |
Taper Shank Front Cap | |
Adaptor |
|
Fig. 15
English
Grip
Fig. 13
Mounting Depth
Hole Gauge
Knob on Side 
Handle
Fig. 14
Cotter | Taper Snank Adaptor |
Rests
Fig. 16
15
