English

Dump particles after every two or three holes when drilling.

Please replace the drill bit after removing dust collector (B).

8.Selecting the driver bit

Screw heads or bits will be damaged unless a bit appropriate for the screw diameter is employed to drive in the screws.

9.Confirm the direction of bit rotation (Fig. 6)

The bit rotates clockwise (viewed from the rear side) by pushing the R-side of the push button. The L-side of the push button is pushed to turn the bit counterclockwise.

L L Push

R

button

Lock grip

Fig. 7

<Installation>

(1)Mesh the lock grip with spline.

(2)Push in the lock grip, turning it in the derection shown on the lock grip.

(3)To confirm that the lock grip is securely instlled, tentatively try to pull out the lock grip (Fig. 8)

L

R

R

Fig. 6

10.Replacement of the drill chuck holder or the drill bit holder

WARNING:

Prevent accidents, make sure to turn the switch off and disconnect the plug from the receptacle.

CAUTION:

To avoid an injury by accident, before replacing the chuck, remove the tipped tool.

Remove or install the drill chuck or the drill bit holder in the procedures below.

<Removal>

Turn the lock grip in the arrow direction shown on the lock grip and pull out the drill chuck holder or the drill bit holder. (If it is hard to pull out the drill chuck holder or the drill bit holder, align the change lever with the mark and turn the lock grip to pull it out.) (Fig. 7)

HOW TO USE

CAUTION:

To prevent accidents, make sure to turn the switch off and disconnect the plug from the receptacle when the drill pits and other various parts are installed or removed. The power switch should also be turned off during a work break and after work.

1. Switch operation

The rotation speed of the drill bit can be controlled steplessly by varying the amount that the trigger switch is pulled.

10