Hobart C44A ML-104047, C44A ML-104050, C44A ML-38898, C44A ML-38899, C44AW ML-103946, C44AW ML-103947, C44AW ML-104082, C44AW ML-104083, C54A ML-104198, C54A ML-104199, C64A ML-103908, C64A ML-103909, C88A ML-110041, C88A ML-110042, CRS66A ML-38, CRS66A ML-38947 OPERATION

– 20 –

OPERATION

PREPARATION

Put the dishwasher strainer pans and strainer basket (Fig. 3) into position in each dishwasher tank.

If the machine is equipped with an RS, CS, or PW unit, install the solid prewash strainer pan over the

overflow tube, flange side down and the lip toward the rear of the tank. Install one perforated strainer

pan, handle side up, across the rear of the tank. Install the other perforated strainer pan against the load

end of the tank and locate the flange into the notches on the solid and perforated strainer pans. Drop

in the perforated strainer basket (Fig. 11).

Fig. 11 Fig. 12

Hang curtains on open hooks provided. Refer to Curtain Installation.

Move drain lever(s) down to close the drain(s) (Fig. 12), or close the door(s) to automatically push the

lever(s) down.

FILLING THE DISHWASHER

Water must be proper hardness. Recommended hardness range is 4 to 6 grains/gallon.

Turn the Power switch ON (Fig. 1). Leave pumps OFF until machine has completely filled.

If the machine is equipped with an RS, CS or PW unit, the prewash tank will fill last, with overflow

water from the wash tank.

If the machine is equipped with steam heat, the mechanical ball valve (located between the drive motor

and the tank) must be opened by pulling the valve lever down.

Hobart manual OPERATION