– 6 –
PLACING THE ROTOR IN THE OVEN (HR5E)
The rotor must properly engage with the drive mechanism. Orient the rotor so that the end plate with
the drive pin is aligned with the slotted drive hub.
STEP 1: Place the drive end of the rotor shaft into
the slotted drive hub (Fig. 1).
STEP 2: Place the rotor shaft on the support
bearing on the non-drive side of the oven
(Fig. 2).
Fig. 1
Fig. 2
BEFORE FIRST USE
WARNING: DISCONNECT ELECTRICAL POWER SUPPLY TO THE MACHINE AND FOLLOW
LOCKOUT / TAGOUT PROCEDURES BEFORE CLEANING OR SERVICING.
Oven must be burned in to release any odors that might result from heating the new oven surfaces.
1. Clean oven and accessories, both inside and outside. Refer to CLEANING, pages 25 — 39, for
further instructions.
2. Operate oven at maximum temperature setting of 482°F (250°C) for 45 minutes. Smoke with an
unpleasant odor will normally be given off during this burn-in period.
DRIVE SIDE
ROTOR
DRIVE PIN
SLOTTED DRIVE HUB
NON-DRIVE SIDE
SUPPORT BEARING
ROTOR SHAFT