4.Replace existing service cover with one supplied in kit (919277). The power cord will have to be disconnected from the contactor in the control drawer to replace the existing service cover. Assemble the electrical conduit connector to the service cover per Fig 14.

5.Attach electrical conduit to connector and run cold water valve wire harness (919862) through conduit per Fig 14. Make wiring harness connection per Fig 14. Replace valve cover. Attach service cover to dishwasher after all connections have been completed.

6.Make the electrical connections on the cold water valve per Fig 15. Use one of the knock outs on the valve cover to install the electrical conduit connector. Run the cold water valve wire harness (919862) through the connector and install the electrical conduit to the conduit connector.

7.Reinstall motor cover, wire way and base cover to unit after all electrical connections are made.

8.Dress valve electrical conduit so it will not sustain damage when the machine is moved for service or cleaning.

9.Locate existing wiring diagram on dishwasher unit. Locate P1-4 and 2TB-N on diagram.

For Solenoid Drain Units - apply wiring label F-44097-1 from kit to existing diagram between P1-4 and 2TB-N.

For Drain Pump Units - apply wiring label F-44097-2 from kit to existing diagram between P1-4 and 2TB-N.

© HOBART 2008

Page 5 of 8

F25230 (Rev. A, May 2008)