5.Connect the other two wires marked as Drain1 and Drain2 in harness 814267 to drain solenoid valve as shown in Fig. 6.
6.Route the wire harness to the rear of the machine along the left side wall.
7.Use a wire tie to bind the wiring harness to the red float switch wires to ensure it is not lying on the bottom of the dishwasher per Fig. 7.
9.Install the strain relief at other end of electrical conduit per Fig. 9.
10.Use one of the knock outs on the valve cover to install the electrical conduit connector. Run the cold water valve wire harness (919862) through the connector and install the electrical conduit to the conduit connector per Fig.10.
8.Assemble the electrical conduit connector to the strain relief bracket. Attach electrical conduit to connector, run cold water valve wire harness (919862) through conduit per Fig. 8.
11.Attach cold water valve wire harness to cold water valve as shown in Fig. 10.
© HOBART 2008 | Page 7 of 8 | F25230 (Rev. A, May 2008) |