– 10 –
MIXING.
This section explains operation of the mixer and how to install bowls and agitators. A
separate
Use and Applications Handbook, provided with the mixer, contains information
on mixing procedures and outlines specific uses for agitators and accessories.
Bowl
The bowl must be installed before the agitator. To install the bowl, fully lower the bowl
support. Position the bowl so the alignment bracket on the back of the bowl is under the
retainer on the bowl support and the alignment pins on the front of the bowl support fit
in the holes in the bowl. Lock the bowl in place by rotating the bowl clamps over the ears
of the bowl.
If a bowl adapter is required, install it on the bowl support as you would the bowl, and
then install the bowl on the adapter.
Agitator
To install an agitator, the bowl must be installed and fully lowered. Place the agitator
in the bowl, push it up on the agitator shaft, and turn it clockwise to seat the shaft pin
in the slot of the agitator shank.
Bowl Guard (Built Before July, 2004) (Fig. 3)
The Wire Cage Assembly on the Bowl Guard can be rotated out of the way to add
ingredients or access the bowl and agitator. Some ingredients, such as liquids or
powders, may be added through the wire cage assembly while the mixer is in operation.
An ingredient chute accessory is available to assist in adding ingredients. Contact your
local Hobart Sales representative for more information.
Fig. 3