A200 | A200 WITH TIMER |
ON
OFF
| 4 | 5 | 6 | 7 |
|
|
| ||
ON | 3 |
|
| 8 |
2 |
|
| ||
|
|
| 9 | |
| 1 |
|
| |
|
|
|
|
10
OFF | 11 |
|
12
13
15 14
ATTACHMENT HUB
THUMB SCREW
GEAR SHIFT
LEVER
WIRE CAGE
AGITATOR
BOWL
CLAMP
ALIGNMENT
PIN
To Raise the Bowl While Mixing
CONTROL 
PANEL 
Fig. 1
BOWL LIFT HANDLE
SPLASH
GUARD
APRON
BOWL SUPPORT
BOWL LIFT SLIDEWAYS
To raise the bowl while the agitator is mixing the product (when required by recipe or when using the Bowl Scraper Attachment): Load ingredients. Close Wire Cage Assembly. Select Low speed. To begin mixing, hold the
Attachments
To install an attachment, loosen the thumb screw on the attachment hub (Fig. 1) and remove the plug. Insert the attachment into the attachment hub making certain that the square shank of the attachment is in the square driver of the mixer. Secure the attachment by tightening the thumb screw.
Move the gear shift lever to the desired speed and start the mixer to operate the attachment.
The meat and food chopper attachment should be operated in second or third speed. If material in the cylinder stalls the mixer, stop the mixer at once. DO NOT attempt to restart the mixer in a lower speed
—remove the adjusting ring, knife, plate, and worm and clear the obstruction. THIS ATTACHMENT MUST NOT BE USED TO CHOP BREAD CRUMBS.
NOTE: Attachment hub should not be used while mixing.
Bowl Scraper Attachment
The Mixer Bowl Scraper Attachment (when ordered) is provided with a separate instruction manual covering its installation, operation, use and care.
– 5 –
