INSTALLATION
UNPACKING
Immediately after unpacking the slicer, check for possible shipping damage. If the slicer is found to be damaged, save the packaging material and contact the carrier within 15 days of delivery.
Prior to installing the slicer, test the electrical service to make sure that it agrees with the specifications on the machine data plate. The data plate is located on the right side of the slicer base.
CARRIAGE TRAY
Assemble the Carriage Tray Support Arm to the slicer by inserting the Key in the Carriage Pivot (Fig. 7); turn the Knob on the Carriage Tray Support Arm (Fig. 3) clockwise until tight. Refer to page 7 for assembly information.
SHARPENER
The Sharpener should already be mounted on top of the slicer and locked to its bracket (Fig. 1).
TOP KNIFE COVER
The Top Knife Cover should already be in place and secured with its Latch Knob (Fig. 2).
DEFLECTOR
The Deflector (Fig. 1) should already be mounted below the Knife.
FENCE (Low or High)
The Fence (Fig. 1) can be clamped on the Carriage Tray to limit product movement during slicing.
Model 2912B
To Install:
Loosen Thumscrew on Fence. Slide
Fence down from Top of Carriage Tray.
Tighten Thumbscrew.
OR: Lay Fence on Bottom of Carriage Tray.
Rotate to Vertical. Slide Fence Up.
Tighten Thumbscrew.
Fig. 1
ELECTRICAL
WARNING: THIS MACHINE IS PROVIDED WITH A
CLEAN BEFORE USING
Thoroughly clean and sanitize the slicer after installation and before use. Refer to CLEANING, pages 6 – 7.
– 3 –
