![](/images/backgrounds/64853/bgb.png)
– 11 –
To Reinstall the Knife . . .
•Orient the RIDGE on the KNIFE HUB so it points to the PIN on
the RING GUARD at the 1 o'clock position (Fig. 24).
•Place the KNIFE and TOOL so the PIN on the KNIFE REMOVAL
TOOL is at the 11 o'clock position (Fig. 23). The SLOTS on
the KNIFE REMOVAL TOOL fit around the three PINS on the
RING GUARD (FIG. 20).
•If the TOOL does not push the pins on the back of the KNIFE
into the HUB (Fig. 25), slightly nudge the HANDLE upwards
(Fig. 26) to lock the pins into the KNIFE NUT.
•First, push the HANDLE firmly, all the way into the HUB to engage
the pins. Then, turn the HANDLE clockwise until it stops (Fig. 27).
You may experience resistance when turning.
•The KNIFE is reattached. Lift the TOOL up and out.
•Replace the plastic cover on the KNIFE NUT.
Reassemble Slicer Parts
•Place the plastic RING GUARD COVER on the RING GUARD, align
using the three guide PINS (Fig. 14).
•Place the TOP KNIFE COVER on top of the RING GUARD COVER,
aligning with the three guide PINS (Fig. 13). Secure the RING
GUARD COVER and the TOP KNIFE C OVER by turning the LATCH KNOB
(Fig. 7) counterclockwise while lowering the TOP KNIFE COVER;
then, release the LATCH KNOB and turn it clockwise until snug.
•Lower the SHARPENER so the ROD AND
PIN, underneath, fit the SLOT in the
SHARPENER MOUNT (Fig. 12).
•Reinstall the PRODUCT TRAY by holding
it with both hands and lowering the
bottom of the SUPPORT ARM so it fits on
the CARRIAGE HINGE PINS (Fig. 17).
•Return the PRODUCT TRAY to the GAUGE
PLATE by tilting it to the left. Turn the
KNOB on the SUPPORT ARM loosely in
either direction until it moves inward,
then turn it clockwise until snug
(Fig. 28).
To reattach accessories —
refer to page 3.
SHARPENER
KNIFE COVER
KNOB
PRODUCT TRAY
SUPPORT
ARM
Fig. 28
Fig. 26
Fig. 25
Fig. 27