WS-C206/WS-C208 Hobart Compact Water Softener Installation Instructions - INSTALLATION

14.Insert tubing provided into the overflow port on the back of the softener and run drain lower than the cabinet connection to provide a gravity drain in the event of a internal cabinet leak.

Fig. 10

15.Review the meter disc selection chart and the water analysis provided. If no water analysis is provided test the water supply.

16.To test the water supply, use the water analysis test kit available through Pro Products Inc. The recommended kit is #2401 Field Analysis Kit. To order the test kit contact Pro Products at 800- 285-9176 or visit www.ProProducts.com.

17.Determine the correct number disc. DISC SELECTION WS-C206/WS-C208

NOTE: Both the WS-C206 and the WS-C208 have a #4 meter disc installed at the factory. If this is not the correct disc for a given application, locate the meter disc kit and follow instructions for DISC REPLACEMENT WS-C206/WS-C208

18.Remove brine valve assembly from cabinet to set float cup.

19.To remove brine valve assembly, disconnect tubing from valve elbow by holding the collet and pulling tubing straight away. Remove brine valve from softener cabinet.

Fig. 11

20.Remove the brine valve assembly by lifting straight up.

21.Set it on a flat surface, to measure height of float cup.

22.Measure from bottom of brine valve to top of float cup.

Fig. 12

Page 5 of 10

 

F25311 Rev. A (0913)