2-12. Threading Welding Wire
| 1 | Wire Spool |
| 2 | Welding Wire |
| 3 | Inlet Wire Guide |
| 4 | Pressure Adjustment Knob |
| 5 | Drive Roll |
4 | 6 | Outlet Wire Guide |
| 7 | Gun Conduit Cable |
| Lay gun cable out straight. | |
| 7 |
|
Tools Needed:
1 | 2 | 3 | 5 | 6 |
. Hold wire tightly to keep it from unraveling.
6 in 
(150 mm)
Open pressure assembly. | Pull and hold wire; cut off end. |
Tighten
Close and tighten pressure | Remove gun nozzle and contact tip. |
assembly, and let go of wire. |
|
Ref.
4 in 
(102 mm)
Push wire thru guides into gun;
continue to hold wire.
Turn On.
Press gun trigger until wire comes out of gun. Reinstall contact tip and nozzle
WOOD |
|
Feed wire to check drive roll pressure. | Cut off wire. |
Tighten knob enough to prevent slipping. | Close door. |
