ASSEMBLY
INSTRUCTIONS
FRAME ASSEMBLY
Step 2c
In this step start by pressing two Guide Rod Bushings into the
WeightCage. Take the two 3” x 1” I.D. Bumpers and place them over the
two holes in the bottom of the Now slide the Guide Rods into
the holes. Make sure to lube the Guide Rods with Spindle Oil. Next slide
on ten(10) 20 LBS Intermediate WeightPlates and one(1) 15 LBS
Aluminum TopPlate onto the Guide Rods, and bolt into place. Make sure
the WeightStack and its Guide Rods are sitting level. Next, attach the
5/8” Dia. x 6 13/32” Rod to the Center RH BRK ( Add-On). Secure the
Center RH BRK (Add-On) to the . Slide on
three 5 LBS. Add-On Weightsand attach the 5/8” Dia. x 6 13/32” Rod to
the . Attach bigger end of the Selector Pin Lanyard to the
, and the other end to the WeightSelector Pin.
Then bolts including all previously hand tightened boltsWrenchtighten .
WeightCage.
15 LBS Aluminum TopPlate
WeightCage
Center RH BRK ( Add-On)
FITNESSSYSTEMS
R
HOIST
3 - Center RH BRK (Add-On)
10 - Guide Rod
15 - 5/8” Dia. x 6 13/32” (Add-On)
Rod
19 - 15 lbs Aluminum TopPlate
32 - 11 Plate Selector Stem
33 - 20 lbs Intermediate Weight
37 - Add On WeightBushing
Part Descriptions
H - 3/8” x 1 Button Head Screw
G - 5/16” x 1” Button Head Cap Screw
J - 3/8” x 2 3/4” Button Head Cap Screw
Q - 3/8” Flat Washer
R - 3/8” Lock Washer
V - 5/16” Flat Washer
T - 3/8” Internal Lock Washer
AK - Guide Rod Bushing
AL - 3” x 1” I.D. x 1 1/2” THK Bumper
AM - Guide Bearing
AN - Guide Bearing
AP - Selector Pin Lanyard
AT - WeightSelector Pin
AU - 5 lbs Add-On Weight
AW - Insert
BB - 3/8” x 1” Button Head Screw (white zinc)
BC - 3/8” Split Washer
BE - 3/8” Flat Washer
BJ - 5/16” Internal Lock Washer
Hardware Descriptions
Page - 9 2408 Assembly