![](/images/new-backgrounds/1246331/24633111x1.webp)
A SS E M B LY
I N S T R U C T I O N S
Step 2a
F R A M E A S S E M B L Y
In this step attach two Flange Bearings to the Weight Cage. Make sure to put zerk fitting facing down on Flange Bearings. Next attach the 1” Dia. CRS to the Cam Assembly (Large). Slide the other side of the 1” Dia. CRS through the Flange Bearings and the Weight Cage. Attach the Range of Motion, Extension Tube Assembly, and a Red Iodized Aluminum Cap to the 1” Dia. CRS. Hand Tighten bolts only, they will be tightened later. Lift Machine to position Rubber Feet.
Part Descriptions | Hardware Descriptions | |
2 | - Range of Motion | D - 3/8” x 1 1/4” Flat Head Screw |
4 | - Extension Tube Assembly | E - 3/8” x 1 1/4” Button Head Screw |
6 | - Cam Assembly (Large) | T - 3/8” Lock Washer (black) |
7 | - Weight Cage | W - 3/8” x 2 Open Roll Pin |
12 | - 1” Dia. CRS | X - 1” Dia. X .8mm Shims |
23 | - Rubber Feet | AH - Flange Bearing |
34 | - Red Iodized Aluminum Cap | BE - 3/8” Flat Washer |
36 | - Black Plastic Ring |
|
Page - 5
HOIST
FITNESS SYSTEMS
R
2408 Assembly