Home Automation RC-1000 installation instructions Remote Setback Switch, Other Systems

REMOTE SETBACK SWITCH

The thermostat can be connected to a remote switch to toggle the desired heat and cool temperature settings between preset setpoints. A signal can be sent from the remote switch location to change the thermostat temperature settings from the Occupancy Day temperature settings to the Occupancy Night temperature settings. To use this mode, the “Program Options” setting must be set to “Occupancy” - See Program Options.

Run a two-conductor wire from the remote switch to the thermostat location. Make the connections to the Black and Green terminals under the section marked “Comm” on the right terminal strip - See Figure 9.

ANY SYSTEM WITH	THERMOSTAT
A RELAY OR	UP
5 - 15 VDC OUTPUT
	Leave Jumper
	Connected
	Black
	Green

5 -15

VDC

Figure 9 – Connections to a Remote Setback Switch

Notes:

1.When connecting to a remote setback switch, the metal jumper between terminal labeled “N/C” and the terminal labeled “Black” on the right terminal strip must remain in place – See Figure 9.

2.When 0VDC is applied, the desired temperature settings will change to the preset Occupancy Day temperature settings.

3.When 5-15VDC is applied, the desired temperature settings will change to the preset Occupancy Night temperature settings.

OTHER SYSTEMS

For connections to personal computers, utility management systems, and other automation systems, refer to connection diagrams provided with personal computer software package or other system.

10