Connect each wire to the terminal strip(s) on the thermostat base per the wiring diagram for your system application - See Figures 4 - 7. Form the thermostat wiring so that the cable lies flat between the terminal strip(s) and the center of the base - See Figure 2.
If a remote system or temperature sensor is being used with the thermostat, connect the remote system or temperature sensor wiring per the diagram for the application - See Figures 8 - 10.
Upon completion of wiring the thermostat, push all excess wiring into the hole in the wall. Plug the hole with the supplied insulating foam to ensure an accurate temperature reading by the thermostat.
Align the tabs of the thermostat face with the slots of the thermostat base. Gently push the thermostat face into the thermostat base locking it into place - See Figure 2.
Slot Tab
Base Temperature
Sensor
Wall
Figure 2 | Figure 3 |
Note:
Be sure that the thermostat temperature sensor is standing up, and that it has not been damaged during installation - See Figure 3.
3
