Home Automation RC-1000 Location, Removing an existing thermostat, Mounting

Location

When replacing an existing thermostat, install the RC-1000 in the same location. If the existing location doesn't meet the following criteria, choose a new location to mount the RC-1000. When choosing a location for the thermostat:

1.Ensure that the thermostat is mounted 5 feet above the floor and is at least 2 feet from an outdoor wall.

2.Ensure that the thermostat is located in an area where there is adequate air circulation.

3.Do not mount in the path of direct sunlight or of radiant heat generated by appliances.

4.Do not mount behind an outdoor wall, near a fireplace, or in the path of any air ducts.

Removing an existing thermostat

1.Disconnect the power to the control transformer.

2.Remove the cover to the existing thermostat.

3.Disconnect the wires going to each terminal on the thermostat. Label each wire with the letter or number at the terminal.

4.Remove the existing plate or base from the wall.

MOUNTING

When mounting the RC-1000, grasp the thermostat by the sides, avoiding the keys, and unsnap the base from the face. Holding the base to the wall so that the word "UP" is upright and facing you:

1.Mark the two mounting holes on the wall using a pencil.

2.Drill a hole using a 3/16" bit at each mounting hole marking.

3.Install the two wall anchors supplied.

4.Slide the system wires through the opening in the base.

5.Mount the base to the wall using the two #6 x 1/2" self-tapping screws supplied - See Figure 1.

Figure 1

2