Sharp XL-3000 operation manual Basic Operation Setting the Clock, To readjust the clock

Setting the Clock

This may be operated only with the remote control.

In this example, the clock is set for the 12-hour (AM 12:00) display.

1 Press the CLOCK button and within 3 seconds, press the MEMORY button.

2 Within 1 minute, press the PRESET ( or ) button to

select 12-hour or 24-hour display and then press the MEMORY button.

"AM 12:00" The 12-hour display will appear. (AM 12:00 - PM 11:59)

"0:00" The 24-hour display will appear.

(0:00 - 23:59)

Note that this can only be set when the unit is first installed or it has been reset. (Refer to step 3 under "If trouble occurs" on page 30.)

3 Within 1 minute, press the PRESET ( or ) button to adjust the hour and then press the MEMORY button.

zWhen the 12-hour display is selected, "AM" will change au- tomatically to "PM".

4 Within 1 minute, press the PRESET ( or ) button to adjust the minutes and then press the MEMORY button.

zThe hour will not advance even if minutes advance from "59" to "00".

zThe clock starts from "0" second. (Seconds are not dis- played.)

To confirm the time display when the power is on:

Press the CLOCK button.

The time display will appear for about 5 seconds.

Note:

The time will flash at the push of the CLOCK button when the AC power supply is restored after a power failure or unplugging the unit. Readjust the clock as follows.

To readjust the clock:

Perform "Setting the Clock" from the beginning.

To change the 12-hour or 24-hour display:

1Clear all the programmed contents. [Perform to step 3 under "If trouble occurs" on page 30 for details.]

2Perform "Setting the Clock" from the beginning.

Basic Operation - Setting the Clock -

17

01/1/17 XL-3000(U2)2.fm