HoMedics BPA-201 manual Plug the cuff tube into the left side of the unit

1.If the cuff is not assembled, pass the end of the cuff furthest away from the tubing through the metal

D-ring in order to form a loop. The smooth side without the felt material should be on the inside of the cuff loop.

		MUST	FALLBAND
	ARROW	YELLOW
End of cuff	WITHIN
D-ring

2.Plug the cuff tube into the left side of the unit.

­

Insert plug here

(0
.
2~3
8”~1
.cm
2”)
	abov–Position1
	0.
	8
	.
	2
	e in
	elbowchescuff
	–edge
	.(2
	3cm)
Fit
andtofiAllowcuff	miCen

3.Open the arm cuff so that your arm may be placed through it.

4.Remove tight fitting clothing from your upper left arm so

that the cuff can be wrapped around your exposed arm.

5. Position cuff edge 0.8-1.2 inches (2-3cm) above elbow.

6. Center tube over middle of arm.

7. Pull the end of the cuff so that it tightens evenly around your arm. Press the hook and loop material together to secure.

Allow room for 2 fingers to fit between the cuff and your arm.

8.Lay your arm on a table (palm upward) so the cuff is at the same height as your heart. Make sure the tube is not kinked.

15 16