HoMedics BPS-060 warranty Troubleshooting, Specifications

TROUBLESHOOTING

If any abnormality arises during use, please check the following points

SYMPTOMS	POSSIBLE	CORRECTION
	CAUSES
Unit does not turn on	Batteries have	Replace them with
when the	run down.	two new AA alkaline
START/STOP		batteries.
button is pushed.
	Battery polarities	Re-insert the batteries
	have been positioned	in the correct
	incorrectly.	positions.
EE measurement	Cuff has been placed	Wrap the cuff
error symbol shown	incorrectly.	properly so that it is
on display or the		positioned correctly.
blood pressure value
	Did you talk or move	Measure again.
is displayed	during measurement?	Keep arm steady
excessively low		during measurement.
	Shaking of the arm
(or high).	with the cuff on.
E1 error symbol	Air circuit abnormality.	Check cuff connection.
shown on display	Cuff tube may not be	Measure again.
	plugged into monitor
	correctly.
E2 error symbol	Inflation pressure	Turn the unit off, then
shown on display	exceeding 300 mmHg.	measure again.
E3 error symbol	Error determining	Measure again.
shown on display	measurement data.
CA appears on	Recalibration alert.	Refer to page 25 for
display		more information.

Note: If the unit still does not work, contact HoMedics Consumer Relations. Under no circumstance should you disassemble or attempt to repair the unit by yourself. Contact information for HoMedics Consumer Relations Department can be found on the warranty page.

SPECIFICATIONS

Power Source:	Four 1.5V DC (AA) batteries
Measurement	Oscillometric
Method:
Measurement	Pressure: 40~280 millimeters mercury (mmHg)
Range:	Pulse: 40~199 beats/minute
Accuracy:	Pressure: ±3 mmHg
	Pulse: ±5% of reading
Pressure Sensor:	Semi-conductor
Inflation:	Manual Inflation
Deflation:	Automatic Pressure release valve
Memory Capacity:	60 memories
Auto-shut-off:	1 minute after last button operation
Operation	Temperature: 50°F~104°F (10°C ~40°C)
Environment:	Humidity: Less than 85% R.H.
Storage	Temperature: -4°F~140°F (-20°C~60°C)
Environment:	Humidity: Less than 85% R.H.
Weight:	.40 lbs/181 grams (without batteries)
Arm	Standard size adult arm cuff:
Circumference:	9"–13" (23 – 33 cm)
Dimensions:	4.9"(L) x 4"(W) x 2.5"(H)
	125mm(L) x 102mm(W) x 63mm(H)
	Type BF
	Device and cuff are designed to provide
	special protection against electrical shocks.

Note: These specifications are subject to change without notice.

29 30