HoMedics BPS-060 warranty Plug the cuff tube into the left side of the unit

1.If the cuff is not assembled, pass the end of the cuff furthest away from the tubing through the metal D-ring in order to form a loop. The smooth side without the felt material should be on the inside of the cuff loop.

End of cuff				U	S T	O	W	B
							L L		A N	D
						F A
	O W		M		L L
				Y E
R R		H	IN
A	IT
W
D-ring										Felt Material
										on the outside
										of cuff

2. Plug the cuff tube into the left side of the unit.

Insert plug here

3.Open the arm cuff so that your arm may be placed through it.

4.Remove tight fitting clothing from around your upper left arm.

5. Position cuff edge 0.8-1.2 inches (2-3 cm) above elbow.

6. Center tube over middle of arm.

7.Pull the end of the cuff so that it tightens evenly around your arm. Press the hook

and loop material together to secure. Allow room for 2 fingers to fit between the cuff and your arm.

8. Lay your arm on a table (palm upward) so the cuff is at the same height as your heart. Make sure the tube is not kinked.

15 16