INSTRUCTIONS FOR USE
1.Ensure that the unit is unplugged before filling with water. Fill with warm water to the MAX fill line located on the inside of the tub.
NOTE: Heat will only help to maintain the temperature of water placed inside the footspa. It will not heat cold water. For a warm water massage, fill the unit with warm water.
2.Place the unit on the floor in front of a chair. It is recommended to place the product on a towel.
3.Plug the unit into a
4.Sit down and place your feet in the spa.
5.To operate the unit:
to activate vibration massage, press 
to activate Bubble Massage + Keep Warm, press 
Vibration and Bubble massage settings can be used separately or at the same time. N.B. The keep warm function is automatically activated when the bubbles are switched on. The vibration massage can be used with or without water. The bubble massage + keep warm must only be used with water.
6.Enjoy a deep massage by sliding feet back and forth over the stimulating nodes and rollers on the footspa floor.
7.Move your foot over the exfoliating pumice stone to smooth the skin. To change between the coarse and fine stone simple lift the attachment and replace.
8.To turn off, press the buttons again to deactivate. N.B. The product will automatically switch to
9.To empty: First, unplug the unit. Tip the unit, allowing water to pour out along the drain spout (see fig.3). DO NOT pour water over the control panel
MAINTENANCE:
Cleaning
Unplug the appliance and allow to cool before cleaning. Clean only with a soft, slightly damp sponge.
•Do not immerse in any liquid to clean.
•Never use abrasive cleaners, brushes, glass / furniture polish, paint thinner etc to clean.
Storage
Place the appliance in its box or in a safe, dry, cool place. Avoid contact with sharp edges or pointed objects which might cut or puncture the fabric surface. To avoid breakage, DO NOT wrap the power cord around the appliance. DO NOT hang the unit by the cord.
Plug (MODEL ELM-FS100-GB ONLY)
If the plug on this appliance is damaged, it can be replaced with a BS 1363 plug, fitted with a 3A BS 1362 fuse. Only use a 3amp fuse with this appliance. Care must be taken when changing the plug. If in doubt, contact a qualified electrician.
5
GB
