DATE & TIME SET PROCEDURE
1.To adjust the date/time, press the Set button located on the side of the monitor. The display will show a blinking number showing the month.
2.Change the month by pressing the button. Each press will increase the number by one in cycling manner. Press€the Set button again to confirm the entry, and the screen will show a blinking number representing the day of the month.
3.Change the date and time as described in Step 2 above, using the button to change the numbers and the Set button to confirm the entries.
Press the button
blinking month
increasing month
confirm the entry
repeat process to set date and time
APPLYING THE CUff
1.Remove all watches, wrist jewelry, etc. prior to attaching the wrist monitor. Clothing sleeves should be rolled up and the cuff should be wrapped around bare skin for correct measurements.
2.Apply cuff to left wrist with palm facing up as shown in Fig. A.
3.Make sure the edge of the cuff is about 1/4”~1/2” (1 cm) from the palm as shown in Fig. B.
4.In order to insure accurate measurements, fasten the hook and loop strap securely around your wrist so there is no extra space between the cuff and the wrist as shown in Fig. C. If the cuff is not wrapped tight enough, the measurement values will not be accurate.
5.If your physician has diagnosed you with poor circulation in your left arm, place the cuff around your right wrist as shown in Fig. D.
Fig. A
Fig. B
Fig. C
Fig. D
15 | 16 |