Trouble Shooting the Steamer
PROBLEM | CAUSE | SOLUTION |
|
|
|
Steamer fails to heat | Steamer not plugged in | Plug in to electrical outlet |
| ON/OFF switch not in | Push switch to “ON” |
| “ON” position | position. Switch will |
|
| illuminate. |
| Auto shut off engaged | Check water container to |
|
| ensure it is not empty. If |
|
| full, press the reset button |
|
| on side of unit. If empty, |
|
| refill and push reset to |
|
| begin. |
|
|
|
No steam | Water level is low | Turn ON/OFF switch OFF |
|
| and refill water container |
|
|
|
Water drips from nozzle | Condensation in hose | Hold the hose vertically |
|
| and allow water to drain |
|
| back into tank |
|
|
|
Nozzle gurgles | Condensation in hose | Hold the hose vertically |
|
| and allow water to drain |
|
| back into tank |
|
|
|
Steam is intermittent | Mineral | Follow the procedure for |
|
| removing mineral |
|
|
|
NOTE:
1.Water mineral content and conditions will vary in different areas. To insure continued operation of the steamer, never store without cleaning and removing excess water from the reservoir and water container.
2.If the reset light comes on with water in the tank you probably need to remove mineral build- up.
3.In areas where the voltage exceeds 120V, it may be necessary to clean your unit more frequently.
10 | 11 |