HoMedics SS-4000 Setting the Clock, Listening to Nature Sounds, Listening to the Radio

NOTE: Battery must be installed in order for clock memory back-up to operate. In the event of a power failure or disconnection, if the battery is not installed, the clock and alarm will need to be re-set when power is restored.

4.To install battery, remove compartment cover. Insert one 9 Volt battery into the compartment on the bottom of the unit. Replace cover and snap into place.

5.Attach the DC adaptor jack to the base of the unit (Fig 5) and insert the cord into a 120V household outlet.

Setting the Clock

1.Press the HOUR button (Fig 4) until you reach the correct hour.

2.Press the MIN button (Fig 4) until you reach the correct minute.

3.Press the HI/LOW button (Fig 5) to choose between high and low clock brightness.

Note: An LED light (PM indicator) will appear in the upper left hand corner of the clock face during the PM hours. Be sure to set the time for the correct 12-hour period – AM (morning) or PM (evening) (Fig 3).

Listening to Nature Sounds

1.Select the sound you wish to listen to and press the corresponding button (Fig 2). A green LED will light above the POWER button (Fig 4) to indicate the unit is on.

2.To adjust the volume, turn the VOLUME knob (Fig 1) to your desired level.

3.When finished listening to the sounds you may turn them off by pressing the POWER button, or switch to the radio by pressing RADIO (Fig 4).

Note: When the unit is turned on it will always default to the last mode used.

Listening to the Radio

1.Press the RADIO button (Fig 4).

2.Rotate the TUNER (Fig 1) to select a radio station.

3.To adjust the volume, turn the VOLUME knob (Fig 1) to your desired level.

4.When finished listening to the radio you may turn it off by pressing the POWER button, or switch to

a nature sound by pressing the corresponding button (Fig 2).

Note: To change between bands there is an AM/FM switch located on the back of the unit (Fig 5).

Using the Auto-Timer

1.When the power is on and you are listening to a nature sound or the radio you may set a timer so the unit will automatically turn off.

2.Toggle through the TIMER button (Fig 4) until the corresponding LED illuminates next to the time of your choice, 15, 30 or 60 minutes.

Setting and Using the Alarm

1.Press the AL SET button (Fig 4). The time will flash.

2.While the time is flashing press the HOUR button (Fig 4) until you reach the correct hour. Then press the MIN button (Fig 4) until you reach the desired minute.

3.After 5 seconds the alarm set time will stop flashing and it will be programmed, or you may press the AL SET button.

Note: The PM indicator also applies to the alarm. You can review the alarm setting anytime by pressing the AL SET button.

4.To activate the alarm you may choose one of 3 wake options:

a.To wake to BUZZER (Fig 4) press the AL MODE button (Fig 4) once.

b.To wake to a SOUND press the AL MODE button a second time. It will set to the last sound you listened to. If you wish to change it press the sound you wish to

wake to and then press the POWER button (Fig 4).

c.To wake to RADIO press the AL MODE button a third time. You may leave it on the current station or adjust the TUNER.

Note: A green LED will appear next to the wake mode selected to indicate the alarm is set.

6 7