CAUTION CONTINUED
•The electrical cord of this product cannot be replaced. If it sustains damage, you must stop using this product immediately and return it to the HoMedics Service Center for repair. (See the warranty section for HoMedics address.)
•Disconnect the appliance from outlet before putting hands into water.
Assembly and Instructions for Use
1.Unpack the product. Wipe off dust with a damp cloth.
2.Familiarize yourself with the pump. The pump speed is controlled by the dial located at the front of the pump. The speed is indicated by a “min” and “max” (Fig 1). At its highest speed level, the dial will cease to move any further. To decrease the pump speed, move the dial
3.Lead the cord through the cord slot on the bottom of the base. This will ensure that the unit is balanced when placed on a flat surface. Attach the A/C adaptor jack to the base power cord.
DO NOT plug into outlet at this time (Fig. 2).
Figure 2 |
|
|
|
|
| Top Tier |
|
Stones |
|
|
|
| LED Light | Water Supply | |
Figure 1 | Connector | ||
Outlet | Connector | ||
|
|
| |
| Middle Tier |
| |
|
|
| |
| LED Light Cord |
| Stones |
|
|
| |
| PVC |
| |
| Tube |
| |
|
|
| |
|
|
| Pump |
|
|
| Platform |
Base Power |
|
|
|
Cord |
|
| Watermark |
|
| Base |
|
Switch | Supporting | Edge | Base |
| |||
| Poles |
|
|
| Adaptor |
|
|
Figure 3
PUMP | |
| |
| Drawing on Base |
Base Edge |
|
Figure 4
LED Light Socket | Top Tier |
| |
| Water Supply Connector |
LED Light | Larger Hole |
Middle | |
Connector | Tier |
Figure 5
Stones |
Water |
Watermark |
Figure 6 | Figure 7 |
Drip Loop |
4.Place the platform on the supporting poles of the base (Fig. 2).
5.Insert the PVC tube located under middle tier into the pump (Fig. 2).
6.Insert the LED light cord through the small hole located under the middle tier (Fig. 2).
7.Align the
NOTE: Pump position should be corresponding to the drawing on base.
8.Insert the LED light connector into the LED light socket on the bottom of top tier, and then insert the water supply connector on the bottom of top tier into the larger hole of middle tier (Fig. 4).
9.Add clean water into middle tier (Approx. 10oz), and then into base (Approx. 56.5oz). The water level should be even with thewatermark. Next, arrange the stones provided on top tier, middle tier and the platform as desired (Fig. 5).
10.Plug the cord into 120V household outlet. The fountain is controlled by the switch located on the power cord. If pump doesn’t operate, rotate
NOTE: Ensure that the electrical cord loops below the electrical outlet to form a ‘Drip Loop’ (Fig. 6). This will prevent water from running down the cord into the electrical outlet.
11.As this product has two flowing directions, unplug the power source before changing fountain position. To do so, turn top tier counter clockwise 90 degrees. When water has stopped flowing from it, switch the fountain back on (Fig. 7).
4 |
5