HoMedics IB-WFLTRTW, WFL-TRTW instruction manual Small End

c. Insert small end of the connector into the pump. (Fig 9)

d. Insert LED light into the water inlet attached to the top of the fountain. (Fig 10)

e. Insert the large end of the connector into the water inlet attached to the top of the fountain. (Fig 10) NOTE: You must first slide the LED light through the water inlet.

f.Place the fountain top; with pump attached, on the fountain base. (Fig 11)

Figure 9

LED Light

Small End

of Connector

Pump

Connector

Pump

Base

5.Fill base with 50 oz. of clean water. Add enough water so that the top of the pump is completely submerged. (Fig 13)

6.Attach the A/C adaptor jack to the base power cord. DO NOT plug into outlet at this time. (Fig 1)

7.Set the fountain on a level, waterproof surface.

8.Plug the cord into 120V household outlet. The switch located on the power cord controls the fountain. If pump doesn't operate, rotate in-line switch once to turn “on” and once more to turn “off”. Monthly maintenance will add to your pump's life. NOTE: Ensure that the electrical cord loops below the electrical outlet to form a 'Drip Loop' (Fig 14). This will prevent water from running down the cord into the

electrical outlet. Figure 14

Figure 13

50 oz Water

4.Set the assembled fountain top onto the metal stand. Align cord so it runs down the Upper and Lower Legs that contain the cord clips.

NOTE: You may need to carefully bend open the cord clips to allow room for the cord to be inserted. Place cord in clips to minimize appearance. (Fig 12)

Figure 12

Cord Clip

Cord

Figure 10

Top

LED Light

Connector

Water Inlet

Figure 11

Top

Base

Drip Loop

8 9