Assembly and Instructions for Use
1. Unpack the product. Wipe off dust with a damp cloth. (Fig 1)
Figure 1
Top
Base
(1) Upper Ring
Base Cord
(1) Upper Leg with cord clip
Adaptor
(2) Upper Leg
(1) Screwdriver
(1) Leg Holder
(6) Screws in Leg Holder
(6) Screws
(2) Bottom Leg
(1) Bottom Leg with cord clip
(1) Bottom Ring
2.Assemble the fountain stand:
NOTE: For easy reference, each leg is labeled.
a. Place the Bottom Ring on a flat surface allowing the ring to slightly hang over for easy alignment and tightening of screws as shown in Figure 2. Align the holes of the Bottom Ring with the holes on the Bottom Legs and PARTIALLY secure by tightening the screws using the screwdriver provided. Repeat until all three of the Bottom Legs are partially secure. (Fig 2)
NOTE: DO NOT tighten completely at this point.
b. Insert the Bottom Legs into the Leg Holder and adjust so they sit evenly. Now, completely tighten the three screws in the Leg Holder and the three screws in the Bottom Ring. (Fig 3)
NOTE: Before inserting legs, you may need to unscrew the screws from the Leg Holder to allow for the legs to slide in the holder properly.
c. Insert the Upper Legs into the other end of the Leg Holder.
NOTE: The Bottom Leg with the cord clip should be positioned on the same side of the Leg Holder as the Upper Leg with the cord clip. DO NOT tighten screws in Leg Holder at this point. (Fig 4)
Figure 2
Bottom Legs
Bottom Ring
Figure 3
Leg Holder
Bottom Legs
Bottom Ring
Figure 4
Upper Legs
Cord
Clips
Leg Holder
Bottom Ring
4 | 5 |
