OPERATION
OPERATING THE TRIMMER
See Figure 9.
WARNING:
Engine housing may become hot during trimmer opera- tion. Do not rest or place your arm, hand, or any body part against the engine housing during trimmer operation. Only hold the trimmer as shown in Figure 9 with all body parts clear of engine housing. Extended contact with the engine housing may result in burns or other injuries.
WARNING:
Always position the unit on the operator’s right side. The use of the unit on the operator’s left side will expose the operator to hot surfaces and can result in possible burn injury.
WARNING:
To avoid burns from hot surfaces, never operate unit with the bottom of the engine above waist level.
Hold the trimmer with your right hand on the rear handle and your left hand on the front handle. Keep a firm grip with both hands while in operation. Trimmer should be held at a comfortable position with the rear handle about hip height.
Always operate trimmer at full throttle. Cut tall grass from the top down. This will prevent grass from wrapping around the shaft housing and string head which may cause damage from overheating. If grass becomes wrapped around the string head, STOP THE ENGINE, disconnect the spark plug wire, and remove the grass. Prolonged cutting at partial throttle will result in lubricant dripping from the muffler.
WARNING:
Always hold the string trimmer away from your body, keep- ing clearance between your body and the product. Any contact with the housing or string trimmer cutting head can result in burns and/or other serious personal injury.
CUTTING TIPS
See Figures 9 - 10.
Avoid hot surfaces by always keeping the tool away from your body. (Proper operating position shown in figure 9.)
Keep the trimmer tilted toward the area being cut; this is the best cutting area.
The curved shaft trimmer cuts when passing the unit from right to left. The straight shaft trimmer cuts when passing the unit from left to right. This will avoid throwing debris at the operator. Avoid cutting in the dangerous area shown in figure 10.
Use the tip of string to do the cutting; do not force string head into uncut grass.
Wire and picket fences cause extra string wear, even breakage. Stone and brick walls, curbs, and wood may wear string rapidly.
Avoid trees and shrubs. Tree bark, wood moldings, siding, and fence posts can easily be damaged by the string.
ADVANCING STRING USING THE reel-EASY™ Tap Advance System
String advance is controlled by tapping string head on grass while running engine at full throttle.
Run engine at full throttle.
Tap string head on ground to advance string. String
advances each time the head is tapped.
Several taps may be required until string strikes the cut off blade.
Resume trimming.
NOTE: If the string is worn too short you may not be able to advance the string by tapping it on the ground. If so, STOP THE ENGINE, disconnect the spark plug wire, and manually advance the string.
ADVANCING THE STRING MANUALLY
With the engine off and the spark plug wire disconnected, push the spool retainer down while pulling on string(s) to manually advance the string.
CUT-OFF BLADE
This trimmer is equipped with a
Page 8 — English
