OWNER’S MANUAL
Log Supported On Both Ends
1.Make first cut from above log (see Figure 17). Cut 1/3 through diameter of log. This cut will keep section from splintering when cut.
2.Make second cut on underside of log, directly under first cut. Use top of guide bar to make this cut. Cut up to meet first cut. This will keep log from pinching guide bar and chain.
1st Cut
2nd Cut
Figure 17 - Bucking Log When Log Is Supported On Both Ends
TRIMMING A TREE (Pruning)
WARNING: Avoid kickback. Kickback can result in severe injury or death. See Kickback, page 2 to avoid risk of kickback.
WARNING: Do not operate chain saw while
•in a tree
•on a ladder or any other unstable surface
•in any awkward position You may lose control of saw causing severe injury.
WARNING: Do not cut limbs higher than your shoulders.
CAUTION: Seek professional help if facing conditions beyond your ability.
Trimming a tree is the process of cutting limbs from a living tree. Make sure your footing is firm. Keep feet apart. Divide your weight evenly on both feet. Follow direc- tions below to trim a tree.
1.Make first cut six inches from tree trunk on underside of limb. Use top of guide bar to make this cut. Cut 1/3 through diameter of limb (see Figure 11).
2.Move two to four inches farther out on limb. Make second cut from above limb. Continue cut until you cut limb off.
3.Make third cut as close to tree trunk as possible on underside of limb stub. Use top of guide bar to make this cut. Cut 1/3 through diameter of stub.
4.Make fourth cut directly above third cut. Cut down to meet third cut. This will remove limb stub.
| 2nd Cut - | |
4th Cut - | Pruning Cut | |
(to avoid pinching) | ||
Final Stub | ||
| ||
Cut |
|
6"
2" to 4"
1st Cut -
Pruning Undercut (to avoid splintering)
3rd Cut - Stub Undercut (to avoid splintering)
Figure 11 - Cutting A Limb
101414 | 11 |
