Troubleshooting chart (continued)

Factory reset, clearing all memory

1Press the ON/STAND-BY button to turn the power on.

2Press the FUNCTION button repeatedly to select AUDIO IN function.

3Press the button on the main unit and then press and hold down the / button until "RESET" appears.

Caution:

This operation will erase all data stored in memory including clock, timer settings, tuner preset, and CD programme.

Before transporting the unit

Remove the USB memory device and disc from the unit. Then, set the unit to the power stand-by mode. Carrying the unit with the USB memory device or disc left inside can damage the unit.

Care of compact discs

Compact discs are fairly resistant to damage, however mistracking can occur due to an accumulation of dirt on the disc surface. Follow the guidelines below for maximum enjoyment from your CD collection and player.

Do not write on either side of the disc, particularly the non- label side from which signals are read. Do not mark this surface.

Keep your discs away from direct sunlight, heat, and excessive moisture.

Always hold the CDs by the edges. Fingerprints, dirt, or water on the CDs can cause noise or mistracking. If a CD is dirty or does not play properly, clean it with a soft, dry cloth, wiping straight out from the centre, along the radius.

NO

YES

 

Correct

Maintenance

Cleaning the cabinet

Periodically wipe the cabinet with a soft cloth and a diluted soap solution, then with a dry cloth.

Caution:

Do not use chemicals for cleaning (petrol, paint thinner, etc.). It may damage the cabinet.

Do not apply oil to the inside of the unit. It may cause malfunctions.

Specifications

As part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement without prior notice. The performance specification figures indicated are nominal values of production units. There may be some deviations from these values in individual units.

General

Power source

AC 220 - 240 V ~ 50/60 Hz

 

 

Power

Power on: 18 W

consumption

Power stand-by: 0.4 W (*)

 

 

Dimensions

Width:180 mm (7 - 3/32")

 

Height: 121 mm (4 - 49/64")

 

Depth: 239 mm (9 - 13/32")

 

 

Weight

1.60 kg (3.53 lbs.)

 

 

(*)This power consumption value is obtained when the main unit is in stand-by mode.

Amplifier

Output power

MPO: 16 W (8 W + 8 W) (10% T.H.D.)

 

RMS: 10 W (5 W + 5 W) (10% T.H.D.)

 

 

Output

Speakers: 8 ohms

terminals

Headphones: 16 - 50 ohms

 

 

(recommended: 32 ohms)

 

 

Input terminals

AUDIO IN (Analogue input):

 

500 mV/47 k ohms

 

 

CD player

Type

Single disc multi-play compact disc

 

player

 

 

Signal

Non-contact, 3-beam

readout

semiconductor laser pickup

 

 

D/A converter

Multi bit D/A converter

 

 

Frequency

20 - 20,000 Hz

response

 

 

 

Dynamic

90 dB (1 kHz)

range

 

 

 

E-14

Page 15
Image 15
Sharp XL-E12H operation manual Maintenance, Specifications, Troubleshooting chart