Sharp XL-E12H E-12, Enhancing your system, To use timer and sleep operation together, Headphones

Timer and sleep operation (Remote control only) (continued)

4“SLEEP” will appear.

5The unit will enter the power stand-by mode automatically after the preset time has elapsed.

To confirm the remaining sleep time:

1Whilst “SLEEP” is indicated, press the SLEEP button. The remaining time is displayed for about 10 seconds.

To cancel the sleep operation:

Press the ON/STAND-BY button whilst “SLEEP” is indicated. To cancel the sleep operation without setting the unit to the stand-by mode, proceed as follows.

1Whilst “SLEEP” is indicated, press the SLEEP button.

2Within 10 seconds, press the SLEEP button repeatedly to select “SLEEP 00” until “SLEEP” indicator disappears.

■To use timer and sleep operation together

Sleep and timer playback:

For example, you can fall asleep listening to the radio and wake up to CD in the next morning.

1Set the sleep time (see above, steps 1 - 5).

2Whilst the sleep timer is set, set the timer playback (steps 2 - 10, page 11).

Sleep timer setting Timer playback setting End time

10 - 90 minutes		Desired time
Sleep operation will	Timer playback
automatically stop	start time

Enhancing your system

The connection lead is not included. Purchase a commercially available lead as shown below.

XL-E12

Portable audio player, etc.

Audio cable (not supplied)

■Listening to the playback sounds of portable audio player, etc.

1Use a connection lead to connect the portable audio player etc. to the AUDIO IN socket.

2Press the ON/STAND-BY button to turn the power on.

3Press the FUNCTION button repeatedly to select AUDIO IN function.

4Play the connected equipment. If volume level of the connected device is too high, sound distortion may occur. Should this happen, lower the volume of the connected device. If volume level is too low, increase the volume of the connected device.

Note:

To prevent noise interference, place the unit away from the television.

■Headphones

●Do not turn the volume on to full at switch on and listen to music at moderate levels. Excessive sound pressure from earphones and headphones can cause hearing loss.

●Before plugging in or unplugging the headphones, reduce the volume.

●Be sure your headphones have a 3.5 mm (1/8") diameter plug and impedance between 16 and 50 ohms. The recommended impedance is 32 ohms.

●Plugging in the headphones disconnects the speakers automatically. Adjust the volume using the VOLUME control.

E-12