System connection (continued)
■Speaker connection
●Connect the black wire to the minus
plus (+) terminal. | RIGHT | LEFT |
|
|
●Use speakers with an impedance of 8 ohms or more, as lower
impedance speakers can damage
the unit. | RIGHT | LEFT |
●Do not mistake the right and the left
channels. The right speaker is the one on the right side when you face the unit.
●Do not let the bare speaker wires touch each other.
●Do not allow any objects to fall into or to be placed in the bass reflex ducts.
●Do not stand or sit on the speakers. You may be injured.
■AC power connection
After checking all the connections have been made correctly, plug the AC power lead of this unit into the wall socket. If you plug in the unit first, the unit will enter the
Note:
Unplug the AC power lead from the wall socket if the unit will not be in use for a prolonged period of time.
Remote control
■Battery installation
1Open the battery cover.
2Insert the batteries according to the direction indicated in the battery compartment.
When inserting or removing the batteries, push them towards the
3Close the cover.
Caution:
●Replace all old batteries with new ones at the same time.
●Do not mix old and new batteries.
●Remove the batteries if the unit will not be used for a long period of time. This will prevent potential damage due to battery leakage.
●Do not use rechargeable batteries
●Installing the batteries incorrectly may cause the unit to malfunction.
●Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like.
Notes concerning use:
●Replace the batteries if the operating distance is reduced or if the operation becomes erratic. Purchase 2 “AAA” size batteries
●Periodically clean the transmitter on the remote control and the sensor on the unit with a soft cloth.
●Exposing the sensor on the unit to strong light may interfere with operation. Change the lighting or the direction of the unit if this occurs.
●Keep the remote control away from moisture, heat, shock, and vibrations.
General Control
VOLUME
■To turn the power on
Press the
After use:
Press the
■Volume auto set-in
●If you turn off and on the main unit with volume set to 16 or higher, the volume will start at 16.
●If you turn the unit off then on again with the volume level set to less than 16, it will turn on again at the level set.
■Volume control
Turn the volume knob towards VOLUME +/– (on main unit) or press VOL +/– (on remote control) to increase or decrease the volume.
