Assembly, Front Handle | Homelite UT70131, F3040 specification

ASSEMBLY

A barrier handle should be used for ensuring the best control and maximising operator safety.

1.Hold the top and bottom clamp snugly in position on the shaft housing so that handle will be located to the operator’s left.

2.Insert the end of the handle between the clamps.

3.Align the bolt holes and push the long bolt (1/4-20 x 1 1/2 in) through the handle side.

4.Place short bolt (1/4-20 x 1 in) through opposite side of clamp. Install flat washer, lock washers and hex nuts to hold the assembly in place.

5.After assembly is complete, adjust the position of the handle for best balance and comfort.

6.Tighten first the long bolt and then the short bolt.

7.Connect the shoulder strap to the strap hanger adjust to a comfortable position.

NOTE: Do not attempt to remove or modify the spacer. This spacer limits the upper position of the handle grip. See Figure 4.

See Figure 3.

1.Connect the latch on the shoulder strap to the strap hanger.

2.Adjust the strap to a comfortable position.

NOTE: To quickly release the product from the shoulder strap, sharply pull the quick release tab.

BOLT

1/4-20 x 1 in

STRAP

HANGER

SPACER CLAMP

FLAT WASHER

CLAMP

HEX NUT

LOCK WASHER

Fig. 2

SHOULDER

QUICK

STRAP

RELEASE

TAB

LATCH

STRAP

HANGER

Fig. 3