ASSEMBLYOF RECOVERYTANK AND SOLUTION TANK
SeeFigure2
1.Place Recovery Tank into Solution Tank (align the word "VACUUM" on Recovery Tank with "VACUUM" on Solution Tank) and secure with Metal Latch.
2.Insert the plug on the Short Cord from the Solution Tank into the Recovery Tank Power Head.
ASSEMBLYOF HOSE, WANDS, NOZZLEAND SOLUTION TUBING
See Figure 1
1.Assemble the two Straight Wands.
2.Assemble the upper Straight Wand to the Angled Wand of the Hose.
3.Assemble the Floor Nozzle to the lower Straight Wand. NOTE: Be sure locking button engages properly when
assembling straight wands, angled wand, and floor nozzle.
4.Push the Solution Tube
Figure 3,
5.Push Solution Tube into Retaining Clips on Wands. Tub-
ing may be wrapped around Wands to take up excess slack.
6.Attach the Vacuum Hose to Recovery Tank inlet (Vacuum Inlet).
7, Push solution tube quick disconnect nut onto the quick disconnect valve. Turn clockwise so valve posts lock into notches in nut. See DETAIL "B" - Figure 3.
NOTE: To remove metal retaining clips from hose and solution tube, squeeze tube with fingers before removing, Clips will dislodge easily. Also squeeze tube befvre reattaching clips to prevent hose punctures.
SOLUTION TUBE QUICK
DISCONNECT NUT
QUICK DISCONNECT
VALVE
POWERPOWER HEAD
PLUG |
| |
SHORT |
| |
CORD IN | RECOVERY | |
HERE | ||
TANK | ||
|
SHORT
CORD
SOLUTION
TANK
LATCH
TRIGGER SOLUTION TUBE
VALVENUT
RETAINING
CLIP
INLET
