PROBLEM
!.Neither vacuum motor nor pump motor runs.
2.Vacuum motor runs, but lhere is no sp_ay at lhe nozzle.
,Spray from The floor nozzle does not come out evenly,
4, Motor runs but cleaner does not pick up solution from carpet (no exhaust from top of cPeaner).
5 Sp_ay connections leak.
m
POSSIBLE SOLUTIONS*
!.Be sure power switch is in "ON" position,
2. Be sure power cord is plugged in secure!y,
3. Check wall electrical outlet (by piuug,_,_, in Q
1.Be sure Short Cord from Power
2.Check that Solution Tank is full.
3, Be sure Pump Switch is in the "HI" or "LO _
4.Nozzle Ports may be clogged. See ilIust[otic'n b_kTv,.'tc. unclog
t. Unclog the Nozzle Port, See illustration be!ow.
!.Recovery Tank tsfull of dirty water and mus! be emptied. 2, Check for clogged hose o,,nozzle. C._og_ co,._d ._e ._t from
picking up materialsuch as carpet strings,shoe'
1, Disassemble. nut at leaking connection. Be scue w,._s[<, i,;- properly seated, Rea&semble and +_*'_,+^'- =c, ....- _,,
*Ifthe "Possible Solutions" to "Problems" listed in the chart do not correct the problem, take your ciea[_e_ to QSears
Service Center for professional service. Repairs not listed in this chart require professional and specific k_owledge of this model cleaner and could resull in safety hazards and personal injuryif r_otmade by a qual[_ed Sear_ Service
Technician.
TO UNCLOG NOZZLEPORT
See Figure 18
1._msert the point of a needle or pm into Spray Port to unclog.
NOTE: Do not let the point of needle or pin touch any part of the Spray Pad surface or Spray Pad will not spray scflution properly.
SPRAY POR!
\\
x
CAUTION: Do not _et needi÷ or pin touch this. surface,
\
\
\