Kenmore 175.869039 manual Carpetpreparation, Cleaning Solution, Powercord And Switch, Pump Switch

CARPETPREPARATION

For best results prepare carpet for cleaning as follows:

1.Vacuum carpet to remove loose dirt before using Cleaner.

2.To remove stains and ground in dirt present in heavy traffic areas of the carpet, spray or rub Sears Heavy Traffic Pre-

Treatment (82833) into carpet before using Cleaner. Follow directions on the bottle.

FILLING CLEANER WITH WATER AND

CLEANING SOLUTION	FILLER
See Figure 4	)PENING

1.Open lid of the Filler Opening.

2.Add Sears All In One Carpet Cleaner (82813) solution or Sears Upholstery Cleaner (82843) solution to Solution Tank

(depending on type of cleaning to be performed). Follow directions on label of bottle.

3.Pour clean, hot water (from tap) into Filler Opening in the Solution Tank --use two (2) gallons of water.

4.Close Filler Opening.

NOTE: This unit may become damaged if boiling water is used.

POWERCORD AND SWITCH

See Figure 5

1.Make sure Short Cord is plugged in as shown.

2.Plug Power Cord into electrical outlet.

3.Turn Power Switch to "ON" position.

PUMP SWITCH

See Figure 5

1.Place Pump Switch from "OFF" position to either "HI" or "LO" position.

NOTE: "HI" pump speed is used for normal cleaning. "LO"

pump speed is used for delicate upholstery or light cleaning.

SOLUTION

TANK

PUMP

SWITCH SHORT

CORD

POWER

SWITCH