ASSEMBLY
WARNING:
Disconnect the spark plug wire before assemblying parts. Failure to do so could result in possible serious personal injury.
ASSEMBLING THE BLOWER TUBES
See Figures 2 - 5.
■Place large clamp on the elbow tube and install the elbow tube onto blower. Tighten large clamp securely.
■Place large clamp on the bellows and install the bellows onto the elbow. Tighten clamp securely.
■Insert upper tube into throttle control handle. Position the throttle control handle in the center of upper tube and tighten wing nut securely.
NOTE: The position of the throttle control handle may be adjusted for the best comfort after the blower is strapped onto the operator's back.
■Place small clamp on the bottom end of the bellows and install the upper tube onto the bellows; tighten clamp securely.
■Join two straight tubes, thread into the upper tube and tighten securely.
■Thread nozzle onto tube assembly and tighten securely.
■Tighten all threaded joints securely.
NOTE: Check all threaded joints after initial run to ensure they are tightened securely.
■Hold the throttle cable against the bellows and install the cable tie. Cable tie should be tight enough to retain the throttle cable to the bellows but still allow for movement.
LARGE CLAMP
ELBOW
TUBE
LARGE CLAMP
BELLOWS | Fig. 2 |
|
|
CONTROL HANDLE
THROTTLE CABLE
UPPER TUBE
WING NUT | Fig. 3 |
|
THROTTLE
CABLE CONTROL
HANDLE
BELLOWS
SMALL CLAMP
UPPER TUBE | Fig. 4 |
|
Page 8
