OPERATION
Fig. 6
ADDING OIL
See Figure 7.
Use HOMELITE Bar and Chain Oil. It is designed for chains and chain oilers, and is formulated to perform over a wide temperature range with no dilution required. Chain saw should use approximately one tank of oil per tank of fuel.
Note: Do not use dirty, used or otherwise contaminated oils. Damage may occur to the oil pump, bar, or chain.
1.Carefully pour the bar and chain oil into the tank.
2.Fill the oil tank every time you fuel the engine.
Fig. 7
STARTING THE ENGINE
See Figures 8 through 14.
WARNING:
Keep your body to the left of the chain line. Never straddle the saw or chain, or lean over past the chain line.
1.Place the chain saw on level ground and ensure that no objects or obstructions are in immediate vicinity that could come in contact with the bar and chain.
2.Hold the front handle firmly with the left hand and put your right foot onto the base of the rear handle.
Fig. 8
IGNITION SWITCH
IN THE RUN
POSITION
Fig. 9
PRIMER BULB
Fig. 10
Page 11
