MAINTENANCE
Remove the clutch cover.
Remove the bar and chain from the mounting surface.
Remove the old chain from the bar.
Lay out the new saw chain in a loop and straighten any kinks. The cutters should face in the direction of chain rotation. If they face backwards, turn the loop over.
Place the chain drive links into the bar groove as shown.
Position the chain so there is a loop at the back of the bar.
Hold the chain in position on the bar and place the loop around the sprocket.
CUTTERS CHAIN ROTATION
ADJUSTING
PIN
CHAIN TENSIONING
PIN HOLE
| BAR | |
CHAIN DRIVE LINKS | MOUNTING | |
NUTS | ||
| ||
| CLUTCH | |
| COVER | |
| SPROCKET |
Fig. 39
Fig. 37
BAR
GROOVE
CHAIN DRIVE LINKS
Fig. 38
Page 22
CHAIN TENSIONING |
SCREW |
Fig. 40 |
