OWNER’S MANUAL
SAW CHAIN
TENSION ADJUSTMENT
WARNING: Unplug chain saw from power source before adjust- ing saw chain tension.
WARNING: Cutting edges on chain are sharp. Use protective gloves when handling chain.
WARNING: Maintain proper chain tension always. A loose chain will increase the risk of kickback.A loose chain may jump out of guide bar groove. This may injure operator and damage chain. A loose chain will cause chain, guide bar, and sprocket to wear rapidly.
4.After chain tension is correct, tighten guide bar nuts firmly. If not, guide bar will move and loosen chain tension. This will increase the risk of kickback. This can also damage saw. Note: A new chain will stretch. Check new chain after first few minutes of operation. Allow chain to cool down. Readjust chain tension.
FILLING OIL TANK
1.Remove oil cap.
2.Fill oil tank with SAE #30 motor oil. Note: For temperatures below 30°F, use SAE #10 oil. For temperatures above 75°F, use SAE #40 oil.
3.Replace oil cap at once. Tighten oil cap firmly for good seal. This will avoid oil seepage from tank.
4.Wipe off excess oil.
Note: It is normal for oil to seep when saw is not in use. Empty oil tank after each use to prevent seepage.
Note: For
1.Before adjusting chain, make sure guide bar nuts are only finger tight (see Figure 3, page 6). Also make sure adjusting block is in oval adjusting hole on guide bar (see Figures 3 and 4, page 6).
2.Turn adjusting screw clockwise until all slack is out of chain (see Figure 5). Note: There should be no gap between side links of chain and bottom of guide bar (see Figure 6).
3.Wearing protective gloves, move chain around guide bar. Chain should move freely. If chain does not move freely, loosen chain by turning adjusting screw counterclockwise.
Figure 5 - Turning Adjusting Screw
Guide Bar Nuts
Guide Bar
Guide Bar
Correct
Gap
Tension
Incorrect
Tension
Figure 6 - Saw Chain Adjustment
120693 | For more information, visit www.desatech.com |
