ASSEMBLY
If your unit has been preassembled, check each step to make sure the unit has been properly assembled.
FRONT HANDLE
See Figure 2.
nRemove the front handle, bolt, and wing nut from the Owner’s Kit.
nInstall the front handle onto the top side of the drive shaft housing and move it to a comfortable position.
nPlace the bolt through the front handle as shown, then install the wing nut.
nTighten wing nut securely.
CURVED SHAFT GRASS DEFLECTOR WITHOUT EDGER GUIDE - TRIMLITE AND TRIM ‘N EDGE
See Figure 3.
nRemove wing nut, flat washer, lock washer, and bolt from the Owner’s Kit.
nPlace curved shaft grass deflector over shaft and brack- et.
nInstall bolt through the slots in the tabs on grass deflector and bracket on shaft housing.
nInstall flat washer, lock washer and wing nut.
nTighten Securely.
CURVED SHAFT GRASS DEFLECTOR WITH EDGER GUIDE - TRIM ‘N EDGE ONLY
EDGER GUIDE ASSEMBLY
See Figure 4.
nAssemble the two plastic pieces of the edger guide together using the short bolt, flat washer, lock washer and wing nut.
nSlide the edger guide to adjust it to the desired trimming length.
nTighten the wing nut securely.
FRONT HANDLE
WING NUT
BOLT
BRACKET
EDGER GUIDE
PIECES
BOLT
Fig. 2
GRASS
DEFLECTOR
LOCK WASHER
FLAT |
|
|
WASHER | WING NUT | Fig. 3 |
| ||
|
|
WING NUT
LOCK
WASHER
FLAT WASHER
SHORT BOLT
Fig. 4
Page 10
