ASSEMBLY
If your unit has been preassembled, check each step to make sure the unit has been properly assembled.
FRONT HANDLE
See Figure 2.
1.Remove the front handle, bolt, and wing nut from the Owner’s Kit.
2.Install the front handle onto the top side of the drive shaft housing and move it to a comfortable position.
3.Place the bolt through the front handle as shown, then install the wing nut.
4.Tighten wing nut securely.
GRASS DEFLECTOR WITHOUT EDGER GUIDE - TRIMLITE AND TRIM ‘N EDGE
See Figure 3.
1.Remove wing nut, flat washer, lock washer, and bolt from the Owner’s Kit.
2.Place grass deflector over shaft and bracket.
3.Install bolt through the slots in the tabs on grass deflec- tor and bracket on shaft housing.
4.Install flat washer, lock washer and wing nut.
5.Tighten Securely.
GRASS DEFLECTOR WITH EDGER GUIDE - TRIM ‘N EDGE ONLY
EDGER GUIDE ASSEMBLY
See Figure 4.
1.Assemble the two plastic pieces of the edger guide together using the short bolt, flat washer, lock washer and wing nut.
2.Slide the edger guide to adjust it to the desired trimming length.
3.Tighten the wing nut securely.
FRONT HANDLE
WING NUT
BOLT
BRACKET
EDGER GUIDE
PIECES
BOLT
Fig. 2
GRASS
DEFLECTOR
LOCK WASHER
FLAT |
|
|
WASHER | WING NUT | Fig. 3 |
| ||
|
|
WING NUT
LOCK
WASHER
FLAT WASHER
SHORT BOLT
Fig. 4
Page 7
