ASSEMBLY
GRASS DEFLECTOR WITH EDGER GUIDE - TRIM ‘N EDGE ONLY (Continued)
See Figures 5 and 6.
1.Remove the wing nut, flat washer, lock washer, and bolt from the Owner’s Kit.
2.Place the grass deflector over the shaft and bracket.
3.Slide the assembled edger guide over the tabs on the grass deflector and bracket.
4.Place the bolt through the slots in the tabs on the grass deflector and trimmer.
NOTE: Ensure the slots are aligned before installing the bolt.
5.Install the flat washer, lock washer and wing nut.
6.Tighten the wing nut securely.
GRASS DEFLECTOR - EASY REACH
See Figure 7.
1.Remove the wing nut from the Owner's Kit.
2.Place slot in grass deflector over the square tab of the mounting bracket.
3.Rotate the deflector around the drive shaft housing then insert the screw on the grass deflector into the screw hole in the mounting bracket. The mounting surface of the grass deflector should fit flush on the mounting bracket.
4.Install the wing nut and tighten securely.
ASSEMBLED EDGER GUIDE
WING NUT
LOCK
WASHER
FLAT
WASHER
TABS
Fig. 5
LONG BOLT
Fig. 6
WING NUT
SQUARE TAB
SCREW
GRASS
DEFLECTOR
SLOT
Fig. 7
Page 8
