OPERATION
STARTING AND STOPPING
See Figure 12 and 13.
TO START A COLD ENGINE:
1.Lay the trimmer on a flat, bare surface.
2.Push the primer bulb 8 to 10 times.
3.Set the choke lever to the choke position 
.
4.Squeeze the throttle trigger to the full throttle position.
5.Pull the starter until the engine tries to run. No more than 6 pulls.
6.Set the choke lever to the half choke position 
.
7.Hold the trigger and the pull starter rope until the engine runs.
8.Run the engine 30 to 45 seconds at full throttle (with the
trigger depressed fully) on half choke position 
to warm up the engine. Move the choke lever to the run position 
.
TO START A WARM ENGINE:
1.Move the choke lever to the run position 
.
2.Hold the trigger and pull the starter rope until the engine
runs.
TO STOP THE ENGINE: |
|
To stop the engine, push and hold the STOP button until the | CHOKE LEVER |
engine stops. |
|
PRIMER BULB
THROTTLE
TRIGGER
Fig. 12
PRIMER BULB
RUN POSITION
3 |
| |
2 | HALF | |
1 | ||
| ||
| CHOKE | |
| POSITION |
STOP
CHOKE
POSITION
STOP BUTTON
Fig. 13
Page 12
